another 1st project

Ordered my frame yesterday and looking forward to get going

Hi Danny hope you enjoy the build as much as i am

Im sure i will
I've been looking at your thread too
impressed

just got me my doner 750 gsxr

did ya go water cooled or oil cooled in the end?

I lost out on the water 1 and was a bit gutted then i came across a belting oil cooled 1

Yeah baby my frame come today
And i pick my donor up on Saturday

Ok I've got a problem the donor i got has a 190 back wheel but the axel is too fat for the frame could i just get another or not

by how much is the spindle too big? If it is 1 or 2 mm then you could open the slots in the frame or if it is massively larger then you could use a GSXR spindle with a sleeve to reduce the inner diameter of the bearings in the wheel, or use a GSXR spindle and get a set of wheel bearings with the outer diameter of the existing bearing and the inner diameter of the GSXR spindle

Think the wheel is a hayabusa
spindle size is 28mm
i thought of sleeving it but what about spacing it out

you will need to make the spacers to suit, you should also check the chain alignment as you may have to space the front sprocket to get it into a usable alignment range due to the width of the Busa wheel

hi
You may also have to get a offset gearbox sprocket to compensate for the width of the Busa wheel
I used a Busa swinging arm n wheel on my streetfighter,having to have a offset sprocket made to compensate for the extra width of the wheel

Ill have to get looking into it
thanks

Ok so so far over the last week I've stripped the gixxer
And got the motor and front end on don't no if this pic will work but hey ho